lkml.org 
[lkml]   [2017]   [Oct]   [17]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCHv3 06/12] ARM: dts: imx6-tx6: specify ethernet phy reset post-delay
Date
Under certain circumstances the ethernet PHY cannot be detected on
Ka-Ro electronics TX6 modules. Using a phy-reset-post-delay of at least
2ms alleviates this problem. Define it to 10ms to be on the safe side.

Signed-off-by: Lothar Waßmann <LW@KARO-electronics.de>
---
arch/arm/boot/dts/imx6qdl-tx6.dtsi | 1 +
1 file changed, 1 insertion(+)

diff --git a/arch/arm/boot/dts/imx6qdl-tx6.dtsi b/arch/arm/boot/dts/imx6qdl-tx6.dtsi
index f2cd3e7..f1655b3 100644
--- a/arch/arm/boot/dts/imx6qdl-tx6.dtsi
+++ b/arch/arm/boot/dts/imx6qdl-tx6.dtsi
@@ -249,6 +249,7 @@
clock-names = "ipg", "ahb", "ptp", "enet_out";
phy-mode = "rmii";
phy-reset-gpios = <&gpio7 6 GPIO_ACTIVE_LOW>;
+ phy-reset-post-delay = <10>;
phy-handle = <&etnphy>;
phy-supply = <&reg_3v3_etn>;
status = "okay";
--
2.1.4
\
 
 \ /
  Last update: 2017-10-17 11:22    [W:0.200 / U:0.472 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site