lkml.org 
[lkml]   [2017]   [Oct]   [12]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
    Patch in this message
    /
    From
    Subject[PATCH v2 4/5] scsi/ufs: qcom: Set phy mode based on the controllers HS MODE
    Date
    Set the phy mode based on the UFS HS PA mode. This lets the
    controller let phy know the mode in which the PHY Adapter is
    running and set the phy rates accordingly.

    Signed-off-by: Vivek Gautam <vivek.gautam@codeaurora.org>
    Reviewed-by: Subhash Jadavani <subhashj@codeaurora.org>
    ---

    Changes since v1:
    - none.

    drivers/scsi/ufs/ufs-qcom.c | 3 +++
    1 file changed, 3 insertions(+)

    diff --git a/drivers/scsi/ufs/ufs-qcom.c b/drivers/scsi/ufs/ufs-qcom.c
    index 6a548e74d704..942e40c9eaf7 100644
    --- a/drivers/scsi/ufs/ufs-qcom.c
    +++ b/drivers/scsi/ufs/ufs-qcom.c
    @@ -273,6 +273,9 @@ static int ufs_qcom_power_up_sequence(struct ufs_hba *hba)
    bool is_rate_B = (UFS_QCOM_LIMIT_HS_RATE == PA_HS_MODE_B)
    ? true : false;

    + if (is_rate_B)
    + phy_set_mode(phy, PHY_MODE_UFS_HS_B);
    +
    /* Assert PHY reset and apply PHY calibration values */
    ufs_qcom_assert_reset(hba);
    /* provide 1ms delay to let the reset pulse propagate */
    --
    QUALCOMM INDIA, on behalf of Qualcomm Innovation Center, Inc. is a member
    of Code Aurora Forum, hosted by The Linux Foundation
    \
     
     \ /
      Last update: 2017-10-12 08:21    [W:3.233 / U:0.236 seconds]
    ©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site