lkml.org 
[lkml]   [2017]   [Jan]   [9]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2] drm: Schedule the output_poll_work with 1s delay if we have delayed event
Date
Instead of scheduling the work to handle the initial delayed event, use 1s
delay.

This delay should not be needed, but Optimus/nouveau will fail in a
mysterious way if the delayed event is handled as soon as possible like it
is done in drm_helper_probe_single_connector_modes() in case the poll
was enabled before.

Reverting 339fd36238dd would give back the 10 sec (!) delay to handle the
delayed event. Adding 1sec delay to the poll_work is enough to work around
the issue in Optimus setups and gives shorter response on handling the
initial delayed event.

Fixes: 339fd36238dd ("drm: drm_probe_helper: Fix output_poll_work scheduling")
Cc: stable@vger.kernel.org # v4.9
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
---
drivers/gpu/drm/drm_probe_helper.c | 10 +++++++++-
1 file changed, 9 insertions(+), 1 deletion(-)

diff --git a/drivers/gpu/drm/drm_probe_helper.c b/drivers/gpu/drm/drm_probe_helper.c
index 06a62e37fbdc..258abed43e38 100644
--- a/drivers/gpu/drm/drm_probe_helper.c
+++ b/drivers/gpu/drm/drm_probe_helper.c
@@ -146,8 +146,16 @@ void drm_kms_helper_poll_enable_locked(struct drm_device *dev)
drm_connector_list_iter_put(&conn_iter);

if (dev->mode_config.delayed_event) {
+ /*
+ * Use short (1s) delay to handle the initial delayed event.
+ * This delay should not be needed, but Optimus/nouveau will
+ * fail in a mysterious way if the delayed event is handled as
+ * soon as possible like it is done in
+ * drm_helper_probe_single_connector_modes() in case the poll
+ * was enabled before.
+ */
poll = true;
- delay = 0;
+ delay = HZ;
}

if (poll)
--
2.11.0
\
 
 \ /
  Last update: 2017-01-09 15:34    [W:0.074 / U:4.356 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site