lkml.org 
[lkml]   [2017]   [Jan]   [12]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v5] DAX: enable iostat for read/write
From
Date
On Thu, 2017-01-12 at 11:38 -0700, Toshi Kani wrote:
> DAX IO path does not support iostat, but its metadata IO path does.
> Therefore, iostat shows metadata IO statistics only, which has been
> confusing to users.
[]
> diff --git a/fs/dax.c b/fs/dax.c
[]
> @@ -1058,12 +1058,24 @@ dax_iomap_rw(struct kiocb *iocb, struct iov_iter *iter,
> {
> struct address_space *mapping = iocb->ki_filp->f_mapping;
> struct inode *inode = mapping->host;
> + struct gendisk *disk = inode->i_sb->s_bdev->bd_disk;
> loff_t pos = iocb->ki_pos, ret = 0, done = 0;
> unsigned flags = 0;
> + unsigned long start = 0;
> + int do_acct = blk_queue_io_stat(disk->queue);
>
> if (iov_iter_rw(iter) == WRITE)
> flags |= IOMAP_WRITE;
>
> + if (do_acct) {
> + sector_t sec = iov_iter_count(iter) >> 9;
> +
> + start = jiffies;
> + generic_start_io_acct(iov_iter_rw(iter),
> + min_t(unsigned long, 1, sec),

I believe I mislead you with a thinko.

Your original code was
(!sec) ? 1 : sec
and I suggested incorrectly using min_t

It should of course be max_t. Sorry.

Also, as sec is now sector_t (u64), perhaps this
unsigned long cast is incorrect.


\
 
 \ /
  Last update: 2017-01-12 19:04    [W:0.074 / U:0.520 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site