lkml.org 
[lkml]   [2017]   [Jan]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v8 3/3] arm64: dts: exynos: Add support for S6E3HA2 panel device on TM2 board
From
Date
On 11.01.2017 07:33, Hoegeun Kwon wrote:
> From: Hyungwon Hwang <human.hwang@samsung.com>
>
> This patch add the panel device tree node for S6E3HA2 display
> controller to TM2 dts.
>
> Signed-off-by: Hyungwon Hwang <human.hwang@samsung.com>
> Signed-off-by: Andrzej Hajda <a.hajda@samsung.com>
> Signed-off-by: Chanwoo Choi <cw00.choi@samsung.com>
> Signed-off-by: Hoegeun Kwon <hoegeun.kwon@samsung.com>
> Tested-by: Chanwoo Choi <cw00.choi@samsung.com>
> ---
> arch/arm64/boot/dts/exynos/exynos5433-tm2.dts | 12 ++++++++++++
> 1 file changed, 12 insertions(+)
>
> diff --git a/arch/arm64/boot/dts/exynos/exynos5433-tm2.dts b/arch/arm64/boot/dts/exynos/exynos5433-tm2.dts
> index ddba2f8..6d362f9 100644
> --- a/arch/arm64/boot/dts/exynos/exynos5433-tm2.dts
> +++ b/arch/arm64/boot/dts/exynos/exynos5433-tm2.dts
> @@ -18,6 +18,18 @@
> compatible = "samsung,tm2", "samsung,exynos5433";
> };
>
> +&dsi {
> + panel@0 {
> + compatible = "samsung,s6e3ha2";
> + reg = <0>;
> + vdd3-supply = <&ldo27_reg>;
> + vci-supply = <&ldo28_reg>;
> + reset-gpios = <&gpg0 0 GPIO_ACTIVE_LOW>;
> + enable-gpios = <&gpf1 5 GPIO_ACTIVE_HIGH>;
> + te-gpios = <&gpf1 3 GPIO_ACTIVE_HIGH>;
The same here (as in 1st comment) , te-gpios should be dropper - decon
uses hw-trigger.

Regards
Andrzej
> + };
> +};
> +
> &hsi2c_9 {
> status = "okay";
>


\
 
 \ /
  Last update: 2017-01-11 08:47    [W:0.146 / U:0.872 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site