lkml.org 
[lkml]   [2016]   [Sep]   [5]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [RFC PATCH] pinctrl: Add SX150X GPIO Extender Pinctrl Driver
On Thu, Aug 25, 2016 at 3:11 PM, Neil Armstrong <narmstrong@baylibre.com> wrote:

> Since the I2C sx150x GPIO expander driver uses platform_data to managed
> the pins configurations, rewrite the driver as a pinctrl driver using
> pinconf to get pin configurations from DT.
>
> The pinctrl driver is functionnally as the gpio-only driver equivalent
> and can use DT for pinconf.
>
> Signed-off-by: Neil Armstrong <narmstrong@baylibre.com>

Overall I'd say this is a nice rewrite. I'd like the following:

- Include Peter Rosin, Wei Chen, Roland Stigge and Vladimir
Zapolskiy on subsequent posts
(Added on To:) ideally I want Tested-by: tags from them
to verify that it doesn't break their current set-ups
(does it? Especially LPC32xx)

- We need a migration plan: everything that was selecting
GPIO_SX150X before should now select this instead.
Just let the Kconfig entry in the drivers/gpio/Kconfig select
this new driver?

- Make sure it is a slot-in replacement. Else make sure it
is.

- Delete the old sx150x driver from drivers/gpio in the same
patch. I'd hate to maintain them side by side. If I apply this,
the old one must go out at the same time. Conversely I can
revert the patch and get the old driver back.

- Strangely I don't see refernces to this driver in any
device tree. Are people not upstreaming their boards?

Yours,
Linus Walleij

\
 
 \ /
  Last update: 2016-09-17 09:58    [W:0.071 / U:0.692 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site