lkml.org 
[lkml]   [2016]   [Sep]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 3/3] tty: serial: xuartps: Wait for rx and tx reset done status
Date
After issuing the reset, driver is not checking the rx and tx reset
done status. So, modified driver to wait for the reset done status.

Signed-off-by: Nava kishore Manne <navam@xilinx.com>
---
Changes for v2:
-Added New patch

drivers/tty/serial/xilinx_uartps.c | 8 ++++++++
1 file changed, 8 insertions(+)

diff --git a/drivers/tty/serial/xilinx_uartps.c b/drivers/tty/serial/xilinx_uartps.c
index 527526e..b69dea3 100644
--- a/drivers/tty/serial/xilinx_uartps.c
+++ b/drivers/tty/serial/xilinx_uartps.c
@@ -694,6 +694,10 @@ static void cdns_uart_set_termios(struct uart_port *port,
ctrl_reg |= CDNS_UART_CR_TXRST | CDNS_UART_CR_RXRST;
writel(ctrl_reg, port->membase + CDNS_UART_CR);

+ while (readl(port->membase + CDNS_UART_CR) &
+ (CDNS_UART_CR_TXRST | CDNS_UART_CR_RXRST))
+ cpu_relax();
+
/*
* Clear the RX disable and TX disable bits and then set the TX enable
* bit and RX enable bit to enable the transmitter and receiver.
@@ -797,6 +801,10 @@ static int cdns_uart_startup(struct uart_port *port)
writel(CDNS_UART_CR_TXRST | CDNS_UART_CR_RXRST,
port->membase + CDNS_UART_CR);

+ while (readl(port->membase + CDNS_UART_CR) &
+ (CDNS_UART_CR_TXRST | CDNS_UART_CR_RXRST))
+ cpu_relax();
+
/*
* Clear the RX disable bit and then set the RX enable bit to enable
* the receiver.
--
2.1.2
\
 
 \ /
  Last update: 2016-09-17 09:59    [W:0.100 / U:0.092 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site