lkml.org 
[lkml]   [2016]   [Aug]   [9]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 2/4] ARM: dts: da850: Add an aemif node
Date
Currently the davinci da8xx boards use the mach-davinci aemif code.
Instantiating an aemif node into the DT allows to use the ti-aemif
memory driver and is another step to better DT support.
Also it will allow to properly pass the emif timings via DT.

Signed-off-by: Karl Beldan <kbeldan@baylibre.com>
---
arch/arm/boot/dts/da850.dtsi | 10 ++++++++++
1 file changed, 10 insertions(+)

diff --git a/arch/arm/boot/dts/da850.dtsi b/arch/arm/boot/dts/da850.dtsi
index bc10e7e..f62928c 100644
--- a/arch/arm/boot/dts/da850.dtsi
+++ b/arch/arm/boot/dts/da850.dtsi
@@ -411,6 +411,16 @@
dma-names = "tx", "rx";
};
};
+ aemif: aemif@68000000 {
+ compatible = "ti,da850-aemif";
+ #address-cells = <2>;
+ #size-cells = <1>;
+
+ reg = <0x68000000 0x00008000>;
+ ranges = <0 0 0x60000000 0x08000000
+ 1 0 0x68000000 0x00008000>;
+ status = "disabled";
+ };
nand_cs3@62000000 {
compatible = "ti,davinci-nand";
reg = <0x62000000 0x807ff
--
2.9.2
\
 
 \ /
  Last update: 2016-08-09 19:41    [W:0.203 / U:1.360 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site