lkml.org 
[lkml]   [2016]   [Jul]   [20]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v2 1/2] tpm: devicetree: document properties for cr50
On Wed, Jul 20, 2016 at 02:03:03PM -0500, Rob Herring wrote:
> On Tue, Jul 19, 2016 at 08:41:24PM -0700, Andrey Pronin wrote:

Hi Rob,

> As I mentioned, there may be common properties. It doesn't seem you
> looked, so I did:
>
> - spi-rx-delay-us - (optional) Microsecond delay after a read transfer.
> - spi-tx-delay-us - (optional) Microsecond delay after a write transfer.
>
> Seems to me setting one or both of these should work for you.
>

Yes, good catch, my fault I didn't see those.
But they are not exactly what I mean and need. I don't need delay after
each read or write transfer. What is needed is a guaranteed time
between transfers.

So, if the next transaction doesn't come withing the next X ms (or us),
we don't waste time on inserting a delays after this transaction at all.
Following the description and always inserting a delay must work well
for short microseconds-long delays. For longer milliseconds-long delays
a different strategy of checking the time when the previous transaction
was and only delaying if it was not too long ago is better.

Thus, I won't be able to re-use these properties anyways based on their
current description in bindings/spi/spi-bus.txt.

> > +- sleep-delay-ms: Time after the last SPI activity, after which the chip
> > + may go to sleep.
> > +- wake-start-delay-ms: Time after initiating wake up before the chip is
> > + ready to accept commands over SPI.
>
> I also asked why these 2 can't be hard-coded in the driver?
>

Sorry, I just updated this patch description in v2 to indicate why they are not
hard-coded, but didn't answer explicitly. As the firmware changes, a different
revision of it can have a different time before it sleeps in its configuration,
or the time it takes it to startup may be different. Thus, there's a way to
set it here w/o changing the driver.

Andrey

\
 
 \ /
  Last update: 2016-07-20 22:21    [W:3.304 / U:0.008 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site