lkml.org 
[lkml]   [2016]   [Jun]   [7]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 3/3] ARM: dts: sun8i-h3: Add dts file for Sinovoip BPI-M2+
On Thu, Jun 02, 2016 at 03:50:11PM +0800, Chen-Yu Tsai wrote:
> The BPI-M2+ is an H3 development board. It is a smaller form factor than
> the original BPI-M2, with the new H3 SoC.
>
> It has 1GB DRAM, 8GB eMMC, a micro SD card slot, HDMI output, 2 USB
> host connector and 1 USB OTG connector, an IR receiver, WiFi+BT based
> on Ampak AP6212.
>
> The board also has a 3 pin header for (debug) UART, a 40 pin GPIO header
> based on the Raspberry Pi B+, but the peripheral signals are not the
> same, and an FPC connector for connecting BPI's camera.
>
> Signed-off-by: Chen-Yu Tsai <wens@csie.org>

I fixed the whitespace error, and applied all three.

Thanks!
Maxime

--
Maxime Ripard, Free Electrons
Embedded Linux, Kernel and Android engineering
http://free-electrons.com
[unhandled content-type:application/pgp-signature]
\
 
 \ /
  Last update: 2016-06-07 23:01    [W:0.085 / U:0.040 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site