lkml.org 
[lkml]   [2016]   [Jun]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v2 2/2] KVM: x86: fix underflow in TSC deadline calculation
On Wed, 29 Jun 2016 19:23:57 +0800
Wanpeng Li <kernellwp@gmail.com> wrote:

> From: Wanpeng Li <wanpeng.li@hotmail.com>
>
> INFO: rcu_sched detected stalls on CPUs/tasks:
> 1-...: (11800 GPs behind) idle=45d/140000000000000/0 softirq=0/0
> fqs=21663 (detected by 0, t=65016 jiffies, g=11500, c=11499, q=719)
> Task dump for CPU 1:
> qemu-system-x86 R running task 0 3529 3525 0x00080808
> ffff8802021791a0 ffff880212895040 0000000000000001 00007f1c2c00db40
> ffff8801dd20fcd3 ffffc90002b98000 ffff8801dd20fc88 ffff8801dd20fcf8
> 0000000000000286 ffff8801dd2ac538 ffff8801dd20fcc0 ffffffffc06949c9
> Call Trace:
> ? kvm_write_guest_cached+0xb9/0x160 [kvm]
> ? __delay+0xf/0x20
> ? wait_lapic_expire+0x14a/0x200 [kvm]
> ? kvm_arch_vcpu_ioctl_run+0xcbe/0x1b00 [kvm]
> ? kvm_arch_vcpu_ioctl_run+0xe34/0x1b00 [kvm]
> ? kvm_vcpu_ioctl+0x2d3/0x7c0 [kvm]
> ? __fget+0x5/0x210
> ? do_vfs_ioctl+0x96/0x6a0
> ? __fget_light+0x2a/0x90
> ? SyS_ioctl+0x79/0x90
> ? do_syscall_64+0x7c/0x1e0
> ? entry_SYSCALL64_slow_path+0x25/0x25
>
> This can be reproduced readily by running a full dynticks guest(since
> hrtimer in guest is heavily used) w/ lapic_timer_advance disabled.
>
> If fail to program hardware preemption timer, we will fallback to
> hrtimer based method, however, a previous programmed preemption timer
> miss to cancel in this scenario which results in one hardware
> preemption timer and one hrtimer emulated tsc deadline timer run
> simultaneously. So sometimes the target guest deadline tsc is earlier
> than guest tsc, which leads to the computation in vmx_set_hv_timer
> can underflow and cause delta_tsc to be set a huge value, then host
> soft lockup as above.
>
> This patch fix it by cancelling the previous programmed preemption
> timer if there is once we failed to program the new preemption timer
> and fallback to hrtimer based method.
>
> Cc: Paolo Bonzini <pbonzini@redhat.com>
> Cc: Radim Krčmář <rkrcmar@redhat.com>
> Cc: Yunhong Jiang <yunhong.jiang@intel.com>
> Signed-off-by: Wanpeng Li <wanpeng.li@hotmail.com>
> ---
> v1 -> v2:
> * abstract the set_hv_timer and cancel_hv_tscdeadline
>
> arch/x86/kvm/lapic.c | 48
> +++++++++++++++++++++++++----------------------- 1 file changed, 25
> insertions(+), 23 deletions(-)
>
> diff --git a/arch/x86/kvm/lapic.c b/arch/x86/kvm/lapic.c
> index 9c20ac1..47ce77c 100644
> --- a/arch/x86/kvm/lapic.c
> +++ b/arch/x86/kvm/lapic.c
> @@ -1366,6 +1366,26 @@ void kvm_lapic_expired_hv_timer(struct
> kvm_vcpu *vcpu) }
> EXPORT_SYMBOL_GPL(kvm_lapic_expired_hv_timer);
>
> +static void start_hv_tscdeadline(struct kvm_lapic *apic)
> +{
> + u64 tscdeadline = apic->lapic_timer.tscdeadline;
> +
> + if (kvm_x86_ops->set_hv_timer(apic->vcpu, tscdeadline)) {
> + if (apic->lapic_timer.hv_timer_in_use)
> + cancel_hv_tscdeadline(apic);

Wanpeng, thanks for the patch.

> + start_sw_tscdeadline(apic);

IMHO, it's not good to start_sw_tscdeadline() on the start_hv_tscdeadline()
function. I think it's expected that the sw_timer is stopped when
start_hv_tscdeadline() returns successsfully, or sw_timer is not impacted if
start_hv_tscdeadline() fails. But it's not expected that start_hv_tscdeadline()
returns successfully while in fact it's the sw_timer started instead :)

Would it be better to simply return failure here, and the caller then
starts the sw_timer?

> + } else {
> + apic->lapic_timer.hv_timer_in_use = true;
> + hrtimer_cancel(&apic->lapic_timer.timer);
> +
> + /* In case the sw timer triggered in the window */
> + if (atomic_read(&apic->lapic_timer.pending))
> + cancel_hv_tscdeadline(apic);
> + }
> + trace_kvm_hv_timer_state(apic->vcpu->vcpu_id,
> + apic->lapic_timer.hv_timer_in_use);
> +}
> +
> void kvm_lapic_switch_to_hv_timer(struct kvm_vcpu *vcpu)
> {
> struct kvm_lapic *apic = vcpu->arch.apic;
> @@ -1373,20 +1393,8 @@ void kvm_lapic_switch_to_hv_timer(struct
> kvm_vcpu *vcpu) WARN_ON(apic->lapic_timer.hv_timer_in_use);
>
> if (apic_lvtt_tscdeadline(apic) &&
> - !atomic_read(&apic->lapic_timer.pending)) {
> - u64 tscdeadline = apic->lapic_timer.tscdeadline;
> -
> - if (!kvm_x86_ops->set_hv_timer(vcpu, tscdeadline)) {
> - apic->lapic_timer.hv_timer_in_use = true;
> - hrtimer_cancel(&apic->lapic_timer.timer);
> -
> - /* In case the sw timer triggered in the
> window */
> - if (atomic_read(&apic->lapic_timer.pending))
> - cancel_hv_tscdeadline(apic);
> - }
> - trace_kvm_hv_timer_state(vcpu->vcpu_id,
> - apic->lapic_timer.hv_timer_in_use);
> - }
> + !atomic_read(&apic->lapic_timer.pending))

Not sure if we could put this check into the start_hv_tscdeadline(). It will also
make the race window all in the same function.

> + start_hv_tscdeadline(apic);
> }
> EXPORT_SYMBOL_GPL(kvm_lapic_switch_to_hv_timer);
>
> @@ -1453,15 +1461,9 @@ static void start_apic_timer(struct kvm_lapic
> *apic) ktime_to_ns(ktime_add_ns(now,
> apic->lapic_timer.period)));
> } else if (apic_lvtt_tscdeadline(apic)) {
> - /* lapic timer in tsc deadline mode */
> - u64 tscdeadline = apic->lapic_timer.tscdeadline;
> -
> - if (kvm_x86_ops->set_hv_timer &&
> - !kvm_x86_ops->set_hv_timer(apic->vcpu,
> tscdeadline)) {
> - apic->lapic_timer.hv_timer_in_use = true;
> - trace_kvm_hv_timer_state(apic->vcpu->vcpu_id,
> -
> apic->lapic_timer.hv_timer_in_use);
> - } else
> + if (kvm_x86_ops->set_hv_timer)
> + start_hv_tscdeadline(apic);

As comments above, would it be good to check the return of
start_hv_tscdeadline() and then start_sw_tscdeadline() if it fails? Just my 2
cents.

Thanks
--jyh

\
 
 \ /
  Last update: 2016-06-29 20:01    [W:0.125 / U:0.828 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site