lkml.org 
[lkml]   [2016]   [Jun]   [23]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 13/14] ARM: dts: sun8i: Add gpio-regulator used on Orange Pi One
Date
From: Ondrej Jirman <megous@megous.com>

Xulong Orange Pi One uses GPIO based regulator that
switches between two voltages: 1.1V and 1.3V. The
regulator is controlled from the PL6 pin.

Signed-off-by: Ondrej Jirman <megous@megous.com>
---
arch/arm/boot/dts/sun8i-h3-orangepi-one.dts | 26 ++++++++++++++++++++++++++
1 file changed, 26 insertions(+)

diff --git a/arch/arm/boot/dts/sun8i-h3-orangepi-one.dts b/arch/arm/boot/dts/sun8i-h3-orangepi-one.dts
index 0adf932..ce4ba91 100644
--- a/arch/arm/boot/dts/sun8i-h3-orangepi-one.dts
+++ b/arch/arm/boot/dts/sun8i-h3-orangepi-one.dts
@@ -88,6 +88,25 @@
gpios = <&r_pio 0 3 GPIO_ACTIVE_LOW>;
};
};
+
+ vdd_soc: gpio-regulator {
+ compatible = "regulator-gpio";
+
+ regulator-name = "soc-vdd-supply";
+ regulator-min-microvolt = <1100000>;
+ regulator-max-microvolt = <1300000>;
+ regulator-boot-on;
+ regulator-type = "voltage";
+
+ gpios = <&r_pio 0 6 GPIO_ACTIVE_HIGH>;
+ states = <1100000 0x0
+ 1300000 0x1>;
+
+ startup-delay-us = <100000>;
+ enable-active-high;
+ };
+};
+
};

&ehci1 {
@@ -131,6 +150,13 @@
allwinner,drive = <SUN4I_PINCTRL_10_MA>;
allwinner,pull = <SUN4I_PINCTRL_NO_PULL>;
};
+
+ soc_reg0: soc_reg@0 {
+ allwinner,pins = "PL6";
+ allwinner,function = "gpio_out";
+ allwinner,drive = <SUN4I_PINCTRL_10_MA>;
+ allwinner,pull = <SUN4I_PINCTRL_NO_PULL>;
+ };
};

&uart0 {
--
2.9.0
\
 
 \ /
  Last update: 2016-06-23 22:21    [W:0.049 / U:0.696 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site