lkml.org 
[lkml]   [2016]   [Jun]   [16]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Subject[PATCH v6 0/2] Add a new Rockchip usb2 phy driver
Date
The newer SoCs (rk3366, rk3399) of Rock-chip take a different usb-phy
IP block than rk3288 and before, and most of phy-related registers are
also different from the past, so a new phy driver is required necessarily.

These series patches add phy-rockchip-inno-usb2.c and the corresponding
documentation.

Changes in v6:
- Changed '_' to '-' for otg-id and otg-bvalid property in devicetree bindings.
- Fixed the output clock would be disabled more than once while phy-port was going to suspend.
- Improved the driver to avoid the currently empty otg-port would cause null-pointer dereferences.

Changes in v5:
- Added 'reg' property both in devicetree bindings and driver to match the different phy-blocks.

Changes in v4:
- Used 'phy-supply' instead of 'vbus_*-supply'.

Changes in v3:
- Supplemented some hardware-description into the devicetree bindings.
- Resolved the mapping defect between fixed value in driver and the property
in devicetree.
- Code cleanup.

Changes in v2:
- Specified more hardware-description into the devicetree bindings.
- Optimized some process of driver.

Frank Wang (2):
Documentation: bindings: add DT documentation for Rockchip USB2PHY
phy: rockchip-inno-usb2: add a new driver for Rockchip usb2phy

.../bindings/phy/phy-rockchip-inno-usb2.txt | 64 ++
drivers/phy/Kconfig | 7 +
drivers/phy/Makefile | 1 +
drivers/phy/phy-rockchip-inno-usb2.c | 655 ++++++++++++++++++++
4 files changed, 727 insertions(+)
create mode 100644 Documentation/devicetree/bindings/phy/phy-rockchip-inno-usb2.txt
create mode 100644 drivers/phy/phy-rockchip-inno-usb2.c

--
1.7.9.5


\
 
 \ /
  Last update: 2016-06-17 04:41    [W:0.126 / U:0.724 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site