lkml.org 
[lkml]   [2016]   [Jun]   [16]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [PATCH 3/4] phy: rockchip-emmc: configure default output tap delay
Date
Am Donnerstag, 12. Mai 2016, 15:43:05 schrieb Brian Norris:
> The output tap delay controls helps maintain the hold requirements for
> eMMC. The exact value is dependent on the SoC and other factors, though
> it isn't really an exact science. But the default of 0 is not very good,
> as it doesn't give the eMMC much hold time, so let's bump up to 4
> (approx 90 degree phase?). If we need to configure this any further
> (e.g., based on board or speed factors), we may need to consider a
> device tree representation.
>
> Suggested-by: Shawn Lin <shawn.lin@rock-chips.com>
> Signed-off-by: Brian Norris <briannorris@chromium.org>

on my rk3399-evb board the emmc still runs nicely with this patch, so

Tested-by: Heiko Stuebner <heiko@sntech.de>

\
 
 \ /
  Last update: 2016-06-17 02:21    [W:0.204 / U:2.524 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site