Messages in this thread | | | Date | Tue, 31 May 2016 10:29:41 +0200 | Subject | Re: [PATCH] pinctrl: pinconf: separate config parameters with commas for debugfs | From | Linus Walleij <> |
| |
On Wed, May 25, 2016 at 8:37 AM, Masahiro Yamada <yamada.masahiro@socionext.com> wrote:
> To improve debugfs readability, use commas instead of whitespaces > for separating configuration parameters. > > For example, the "pinconf-pins" dump on my board will change as follows: > > Without this commit: > > # head -5 pinconf-pins > Pin config settings per pin > Format: pin (name): configs > pin 0 (ED0): input bias pull down output drive strength (8 mA) input enabled > pin 1 (ED1): input bias pull down output drive strength (8 mA) input enabled > pin 2 (ED2): input bias pull down output drive strength (8 mA) input enabled > > With this commit: > > # head -5 pinconf-pins > Pin config settings per pin > Format: pin (name): configs > pin 0 (ED0): input bias pull down, output drive strength (8 mA), input enabled > pin 1 (ED1): input bias pull down, output drive strength (8 mA), input enabled > pin 2 (ED2): input bias pull down, output drive strength (8 mA), input enabled > > Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>
Much better like this, thanks!
Patch applied.
Yours, Linus Walleij
| |