lkml.org 
[lkml]   [2016]   [May]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH 6/6] pinctrl: tegra: Add driver to configure voltage and power state of io pads
From
Date
On 05/11/2016 03:19 AM, Linus Walleij wrote:
> On Mon, May 2, 2016 at 2:17 PM, Laxman Dewangan <ldewangan@nvidia.com> wrote:
>
>> NVIDIA Tegra210 supports the IO pads which can operate at 1.8V
>> or 3.3V I/O voltage levels. Also the IO pads can be configured
>> for power down state if it is not used. SW needs to configure the
>> voltage level of IO pads based on IO rail voltage and its power
>> state based on platform usage.
>>
>> The voltage and power state configurations of pads are provided
>> through pin control frameworks. Add pin control driver for Tegra's
>> IO pads' voltage and power state configurations.
>>
>> Signed-off-by: Laxman Dewangan <ldewangan@nvidia.com>
>>
>> ---
>> Changes from V1:
>> - Use the generic pincontrol property for low power enable/disable.
>> - sync with latest and remove all MODULE* macros
>> - Use renamed APIs form PMC
>
> Looks OK to me, need Stephen's ACK though!

This driver is for HW that's separate from the main Tegra pinmux module.
Thierry Reding and Jon Hunter are more appropriate reviewers for this one.

\
 
 \ /
  Last update: 2016-05-11 18:21    [W:0.148 / U:9.956 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site