lkml.org 
[lkml]   [2016]   [Apr]   [19]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 4/8] gpio: stmpe: write int status register only when needed
Date
From: Patrice Chotard <patrice.chotard@st.com>

On STMPE801/1801 datasheets, it's mentionned writing
in interrupt status register has no effect, bits are
cleared when reading.

Signed-off-by: Amelie DELAUNAY <amelie.delaunay@st.com>
Signed-off-by: Patrice Chotard <patrice.chotard@st.com>
---
drivers/gpio/gpio-stmpe.c | 12 ++++++++----
1 file changed, 8 insertions(+), 4 deletions(-)

diff --git a/drivers/gpio/gpio-stmpe.c b/drivers/gpio/gpio-stmpe.c
index 225e075..f8c9d22 100644
--- a/drivers/gpio/gpio-stmpe.c
+++ b/drivers/gpio/gpio-stmpe.c
@@ -344,12 +344,16 @@ static irqreturn_t stmpe_gpio_irq(int irq, void *dev)
stat &= ~(1 << bit);
}

- stmpe_reg_write(stmpe, statmsbreg + i, status[i]);
-
- /* Edge detect register is not present on 801 and 1801 */
- if (stmpe->partnum != STMPE801 || stmpe->partnum != STMPE1801)
+ /*
+ * interrupt status register write has no effect on
+ * 801 and 1801, bits are cleared when read.
+ * Edge detect register is not present on 801 and 1801
+ */
+ if (stmpe->partnum != STMPE801 || stmpe->partnum != STMPE1801) {
+ stmpe_reg_write(stmpe, statmsbreg + i, status[i]);
stmpe_reg_write(stmpe, stmpe->regs[STMPE_IDX_GPEDR_MSB]
+ i, status[i]);
+ }
}

return IRQ_HANDLED;
--
1.9.1
\
 
 \ /
  Last update: 2016-04-19 14:41    [W:0.191 / U:0.192 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site