lkml.org 
[lkml]   [2016]   [Apr]   [13]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH 6/7] pinctrl: tegra: Add DT binding for io pads control
From
Date

On 13/04/16 10:08, Laxman Dewangan wrote:

[snip]

> For T210, 64 bit, it is
> tegra210.dtsi: pmc: pmc@0,7000e400 {

Yes and this is wrong [0].

>>> +Required properties:
>>> +- compatible: "nvidia,tegra210-io-pad"
>> I think you have have "Must be ..." here. I am also wondering if the
>> pinctrl device should be registered by the pmc driver and so not a
>> separate driver to the PMC driver. In other words, the PMC driver calls
>> pinctrl_register() directly.
>
> I like to keep the pmc driver as main interface and other sub
> functionalities like pad control for voltage and power states, no
> iopower control etc as sub drivers. This will help in modular approach
> of the driver.

OK, let's see what Thierry thinks about this.

>>> +The voltage supported on the pads are 1.8V and 3.3V. The enums are
>>> defined as:
>>> + For 1.8V, use TEGRA210_IO_RAIL_1800000UV
>>> + For 3.3V, use TEGRA210_IO_RAIL_3300000UV
>> You may consider just using integer values here like we do for
>> regulators.
>
> We just support two values 1.8V and 3.3V only. I am fine with either way
> also.
>
>>
>>> + TEGRA210_IO_PAD_DEEP_POWER_DOWN_DISABLE for
>>> + disable.
>>> + TEGRA210_IO_PAD_DEEP_POWER_DOWN_ENABLE for
>>> + enable.
>> Sounds like a boolean parameter. So may consider that if the property
>> 'nvidia,io-pad-deep-power-down' is present then it means enable
>> deep-power-down and if not present then don't. Then you do not need to
>> assign a value to it.
>
> Three states, enable, disable and left default. So absent will be left
> default.

Fine with me.

Cheers
Jon

[0] http://marc.info/?l=linux-tegra&m=146038329109871&w=2

\
 
 \ /
  Last update: 2016-04-13 12:01    [W:0.085 / U:0.864 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site