lkml.org 
[lkml]   [2016]   [Mar]   [23]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH] Fixes: e490c9144cfa ("tty: Add software emulated RS485 support for 8250")
Date
From: Yegor Yefremov <yegorslists@googlemail.com>

When in half-duplex mode RX will be disabled before TX, but not
enabled after deactivating transmitter. This patch enables
UART_IER_RLSI and UART_IER_RDI interrupts after TX is over.

Cc: Matwey V. Kornilov <matwey@sai.msu.ru>
Signed-off-by: Yegor Yefremov <yegorslists@googlemail.com>
---
drivers/tty/serial/8250/8250_port.c | 11 ++++++++++-
1 file changed, 10 insertions(+), 1 deletion(-)

diff --git a/drivers/tty/serial/8250/8250_port.c b/drivers/tty/serial/8250/8250_port.c
index e213da0..00ad263 100644
--- a/drivers/tty/serial/8250/8250_port.c
+++ b/drivers/tty/serial/8250/8250_port.c
@@ -1403,9 +1403,18 @@ static void __do_stop_tx_rs485(struct uart_8250_port *p)
/*
* Empty the RX FIFO, we are not interested in anything
* received during the half-duplex transmission.
+ * Enable previously disabled RX interrupts.
*/
- if (!(p->port.rs485.flags & SER_RS485_RX_DURING_TX))
+ if (!(p->port.rs485.flags & SER_RS485_RX_DURING_TX)) {
serial8250_clear_fifos(p);
+
+ serial8250_rpm_get(p);
+
+ p->ier |= UART_IER_RLSI | UART_IER_RDI;
+ serial_port_out(&p->port, UART_IER, p->ier);
+
+ serial8250_rpm_put(p);
+ }
}

static void serial8250_em485_handle_stop_tx(unsigned long arg)
--
2.1.4
\
 
 \ /
  Last update: 2016-03-23 10:41    [W:0.034 / U:0.332 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site