lkml.org 
[lkml]   [2016]   [Feb]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v5 3/4] Documentation: afe4403: Add DT bindings for the AFE4403 heart monitor
From
Date
On 02/02/16 17:50, Andrew F. Davis wrote:
> Add the TI AFE4403 heart monitor DT bindings documentation.
>
> Signed-off-by: Andrew F. Davis <afd@ti.com>
Given this is near identical to the AFE4404 binding I'll assume the lack of
comment on that means this one is fine too ;)

Applied to the togreg branch of iio.git - initially pushed out as testing
for the autobuilders to ignore it.

Jonathan
> ---
> .../devicetree/bindings/iio/health/afe4403.txt | 34 ++++++++++++++++++++++
> 1 file changed, 34 insertions(+)
> create mode 100644 Documentation/devicetree/bindings/iio/health/afe4403.txt
>
> diff --git a/Documentation/devicetree/bindings/iio/health/afe4403.txt b/Documentation/devicetree/bindings/iio/health/afe4403.txt
> new file mode 100644
> index 0000000..2fffd70
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/iio/health/afe4403.txt
> @@ -0,0 +1,34 @@
> +Texas Instruments AFE4403 Heart rate and Pulse Oximeter
> +
> +Required properties:
> + - compatible : Should be "ti,afe4403".
> + - reg : SPI chip select address of device.
> + - tx-supply : Regulator supply to transmitting LEDs.
> + - interrupt-parent : Phandle to he parent interrupt controller.
> + - interrupts : The interrupt line the device ADC_RDY pin is
> + connected to. For details refer to,
> + ../../interrupt-controller/interrupts.txt.
> +
> +Optional properties:
> + - reset-gpios : GPIO used to reset the device.
> + For details refer to, ../../gpio/gpio.txt.
> +
> +For other required and optional properties of SPI slave nodes
> +please refer to ../../spi/spi-bus.txt.
> +
> +Example:
> +
> +&spi0 {
> + heart_mon@0 {
> + compatible = "ti,afe4403";
> + reg = <0>;
> + spi-max-frequency = <10000000>;
> +
> + tx-supply = <&vbat>;
> +
> + interrupt-parent = <&gpio1>;
> + interrupts = <28 IRQ_TYPE_EDGE_RISING>;
> +
> + reset-gpios = <&gpio1 16 GPIO_ACTIVE_LOW>;
> + };
> +};
>

\
 
 \ /
  Last update: 2016-02-06 20:21    [W:0.026 / U:1.312 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site