lkml.org 
[lkml]   [2016]   [Feb]   [3]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Subject[PATCH v3 0/5] pinctrl: sunxi: Add H3 R_PIO controller support
Date
This patch series is extension of my original single patch with the same
subject. It adds support for R_PIO so that GPIO port L can be used in H3
based devices. It was tested on OrangePi PC where PL is connected amount
others to an onboard led, a switch, an IR receiver and some VCC
controllers.

Patchset is based on next-20160129.

---

Changes since v2:
- fixed apb0 parrent clocks list
- moved binding documentation change to the proper patch
- simplified sunxi_pinctrl_gpio_get according to ChenYu suggestions
- fixed ordering in sunxi binding documentation

Changes since v1:
- splited patch to two separate - dtsi and c files
- added APB0 clocks a parent for R_PIO
- added fix in sunxi_pinctrl_gpio_get for getting pin value when in irq
mode and on 2nd pinctrl
- fixed a "pwn" > "pwm" typo
- fixed order in allwinner,sunxi-pinctrl.txt


Krzysztof Adamski (5):
clk: sunxi: Add apb0 gates for H3
dts: sun8i-h3: Add APB0 related clocks and resets
pinctrl: sunxi: Add H3 R_PIO controller support
ARM: dts: sun8i-h3: Add R_PIO controller node to the dtsi
pinctrl: sunxi: Use pin number when calling sunxi_pmx_set

Documentation/devicetree/bindings/clock/sunxi.txt | 1 +
.../bindings/pinctrl/allwinner,sunxi-pinctrl.txt | 1 +
arch/arm/boot/dts/sun8i-h3.dtsi | 36 +++++++
drivers/clk/sunxi/clk-simple-gates.c | 2 +
drivers/pinctrl/sunxi/Kconfig | 4 +
drivers/pinctrl/sunxi/Makefile | 1 +
drivers/pinctrl/sunxi/pinctrl-sun8i-h3-r.c | 106 +++++++++++++++++++++
drivers/pinctrl/sunxi/pinctrl-sunxi.c | 5 +-
8 files changed, 154 insertions(+), 2 deletions(-)
create mode 100644 drivers/pinctrl/sunxi/pinctrl-sun8i-h3-r.c

--
2.1.4

\
 
 \ /
  Last update: 2016-02-04 01:21    [W:1.113 / U:0.036 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site