lkml.org 
[lkml]   [2016]   [Feb]   [22]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v6 10/12] arm-cci: CCI-500: Work around PMU counter writes
On Mon, Jan 25, 2016 at 11:21:15AM +0000, Suzuki K. Poulose wrote:
> The CCI PMU driver sets the event counter to the half of the maximum
> value(2^31) it can count before we start the counters via
> pmu_event_set_period(). This is done to give us the best chance to
> handle the overflow interrupt, taking care of extreme interrupt latencies.
>
> However, CCI-500 comes with advanced power saving schemes, which
> disables the clock to the event counters unless the counters are enabled to
> count (PMCR.CEN). This prevents the driver from writing the period to the
> counters before starting them. Also, there is no way we can reset the
> individual event counter to 0 (PMCR.RST resets all the counters, losing
> their current readings). However the value of the counter is preserved and
> could be read back, when the counters are not enabled.
>
> So we cannot reliably use the counters and compute the number of events
> generated during the sampling period since we don't have the value of the
> counter at start.
>
> This patch works around this issue by changing writes to the counter
> with the following steps.
>
> 1) Disable all the counters (remembering any counters which were enabled)
> 2) Enable the PMU, now that all the counters are disabled.
>
> For each counter to be programmed, repeat steps 3-7
> 3) Save the current event and program the target counter to count an
> invalid event, which by spec is guaranteed to not-generate any events.
> 4) Enable the target counter.
> 5) Write to the target counter.
> 6) Disable the target counter
> 7) Restore the event back on the target counter.
>
> 8) Disable the PMU
> 9) Restore the status of the all the counters

[...]

> + * For each counter to be programmed, repeat steps 3-7:
> + *
> + * 3) Write an invalid event code to the event control register for the
> + counter, so that the counters are not modified.
> + * 4) Enable the counter control for the counter.
> + * 5) Set the counter value
> + * 6) Restore the event in the target counter
> + * 7) Disable the counter

Steps 6 and 7 are the wrong way around here. They are correct in the
commit message and the code.

[...]

> + * We choose an event code which has very little chances of getting
> + * assigned a valid code for step(2). We use the highest possible
> + * event code (0x1f) for the master interface 0.
> + */

Let's just say:

We choose an event which for CCI-500 is guaranteed not to count.
We use the highest possible event code (0x1f) for master
interface 0.

Otherwise this looks fine.

Mark.

\
 
 \ /
  Last update: 2016-02-22 16:21    [W:0.415 / U:0.036 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site