lkml.org 
[lkml]   [2016]   [Feb]   [10]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v4] regulator: qcom-saw: Add support for SAW regulators
On Wed, Feb 10, 2016 at 10:36:51AM -0800, Stephen Boyd wrote:
> On 02/10, Georgi Djakov wrote:

> > The purpose of this patch it to add support for 8064. Supporting other
> > SoCs requires just read/writing at different offsets. To handle this we
> > can convert the above defines to a table containing the offsets for each
> > SoC. I don't think these are extensive changes or do i miss something?

> In some designs we have to talk to the PMIC with SPMI
> transactions to change the mode depending on the voltages. How do
> we plan to handle that case where the regulator control is split
> between two busses, SPMI and MMIO?

Mixed control interfaces are in general a diaster with Linux, I'd
suggest remonstrating with your system designers about doing them but in
this case since it's a syscon presumably you could hang the device off
the SPMI bus in the cases where that's in use.
[unhandled content-type:application/pgp-signature]
\
 
 \ /
  Last update: 2016-02-10 20:01    [W:0.060 / U:0.168 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site