lkml.org 
[lkml]   [2016]   [Dec]   [7]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v3 1/6] net: stmmac: return error if no DMA configuration is found
Date
From: Niklas Cassel <niklas.cassel@axis.com>

All drivers except pci glue layer calls stmmac_probe_config_dt.
stmmac_probe_config_dt does a kzalloc dma_cfg.

pci glue layer does kzalloc dma_cfg explicitly, so all current
drivers does a kzalloc dma_cfg.

Return an error if no DMA configuration is found, that way
we can assume that the DMA configuration always exists.

Signed-off-by: Niklas Cassel <niklas.cassel@axis.com>
---
drivers/net/ethernet/stmicro/stmmac/stmmac_main.c | 18 +++++++++---------
1 file changed, 9 insertions(+), 9 deletions(-)

diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
index 982c95213da4..14366800e5e6 100644
--- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
+++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
@@ -1578,16 +1578,12 @@ static void stmmac_check_ether_addr(struct stmmac_priv *priv)
*/
static int stmmac_init_dma_engine(struct stmmac_priv *priv)
{
- int pbl = DEFAULT_DMA_PBL, fixed_burst = 0, aal = 0;
- int mixed_burst = 0;
int atds = 0;
int ret = 0;

- if (priv->plat->dma_cfg) {
- pbl = priv->plat->dma_cfg->pbl;
- fixed_burst = priv->plat->dma_cfg->fixed_burst;
- mixed_burst = priv->plat->dma_cfg->mixed_burst;
- aal = priv->plat->dma_cfg->aal;
+ if (!priv->plat->dma_cfg) {
+ dev_err(priv->device, "DMA configuration not found\n");
+ return -EINVAL;
}

if (priv->extend_desc && (priv->mode == STMMAC_RING_MODE))
@@ -1599,8 +1595,12 @@ static int stmmac_init_dma_engine(struct stmmac_priv *priv)
return ret;
}

- priv->hw->dma->init(priv->ioaddr, pbl, fixed_burst, mixed_burst,
- aal, priv->dma_tx_phy, priv->dma_rx_phy, atds);
+ priv->hw->dma->init(priv->ioaddr,
+ priv->plat->dma_cfg->pbl,
+ priv->plat->dma_cfg->fixed_burst,
+ priv->plat->dma_cfg->mixed_burst,
+ priv->plat->dma_cfg->aal,
+ priv->dma_tx_phy, priv->dma_rx_phy, atds);

if (priv->synopsys_id >= DWMAC_CORE_4_00) {
priv->rx_tail_addr = priv->dma_rx_phy +
--
2.1.4
\
 
 \ /
  Last update: 2016-12-07 15:22    [W:0.172 / U:0.168 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site