lkml.org 
[lkml]   [2016]   [Dec]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH RFC] [media] s5k6aa: set usleep_range greater 0
From
Date
On 12/15/2016 02:14 AM, Nicholas Mc Guire wrote:
> if its actually unused then it might be best to completely drop the code
> raher than fixing up dead-code. Is the EXYNOS the only system that had
> this device in use ? If it shold stay in then setting it to the above
> proposed 3000, 4000 would seem the most resonable to me as I asume this
> change would stay untested.

I agree, there little sense in modifying unused code which cannot be
tested anyway. The whole driver is a candidate for removal as it has
no users in mainline. AFAIK it had only been used on Exynos platforms.
I'd suggest to just drop the delay call, there are already usleep_range()
calls after the GPIO state change. IIRC the delay was needed to ensure
proper I2C bus operation after enabling the voltage level translator,
but I'm not 100% sure.

--
Thanks,
Sylwester

\
 
 \ /
  Last update: 2016-12-15 18:47    [W:0.052 / U:0.972 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site