lkml.org 
[lkml]   [2016]   [Nov]   [4]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v6 7/7] arm64: dts: NS2: add AMAC ethernet support
On Fri, Nov 04, 2016 at 04:31:40PM +0300, Sergei Shtylyov wrote:
> Hello.
>
> On 11/4/2016 8:11 AM, Jon Mason wrote:
>
> >Add support for the AMAC ethernet to the Broadcom Northstar2 SoC device
> >tree
> >
> >Signed-off-by: Jon Mason <jon.mason@broadcom.com>
> >---
> > arch/arm64/boot/dts/broadcom/ns2-svk.dts | 5 +++++
> > arch/arm64/boot/dts/broadcom/ns2.dtsi | 12 ++++++++++++
> > 2 files changed, 17 insertions(+)
> >
> >diff --git a/arch/arm64/boot/dts/broadcom/ns2-svk.dts b/arch/arm64/boot/dts/broadcom/ns2-svk.dts
> >index b09f3bc..c4d5442 100644
> >--- a/arch/arm64/boot/dts/broadcom/ns2-svk.dts
> >+++ b/arch/arm64/boot/dts/broadcom/ns2-svk.dts
> >@@ -56,6 +56,10 @@
> > };
> > };
> >
> >+&enet {
> >+ status = "ok";
>
> The spec dictates it should be "okay" (although "ok" is also recognized).

The rest of the file uses "ok". So, the addition above is consistent
with the other entries.

Perhaps a patch outside this series to convert the entire file from
"ok" to "okay" would be acceptable to you.

Thanks,
Jon

>
> >+};
> >+
> > &pci_phy0 {
> > status = "ok";
> > };
> >@@ -174,6 +178,7 @@
> > &mdio_mux_iproc {
> > mdio@10 {
> > gphy0: eth-phy@10 {
> >+ enet-phy-lane-swap;
> > reg = <0x10>;
> > };
> > };
> [...]
>
> MBR, Sergei
>

\
 
 \ /
  Last update: 2016-11-04 17:31    [W:0.047 / U:0.052 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site