lkml.org 
[lkml]   [2016]   [Nov]   [24]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: many "changed bandwidth, new config is" messages in the log
From
Date
On Thu, 2016-11-24 at 15:07 +0000, Michal Hocko wrote:

> I have only now managed to move to 4.9-rc5 (from 4.8) and started
> seeing quite a lot of following messages
> "
> [  346.612211] wlan0: AP c0:4a:00:f1:48:f2 changed bandwidth, new
> config is 2472 MHz, width 1 (2472/0 MHz)
> [  352.655929] wlan0: AP c0:4a:00:f1:48:f2 changed bandwidth, new
> config is 2472 MHz, width 2 (2462/0 MHz)
> "

I don't think these messages are new in any way. checking ... nope,
it's been around that way since 3.9 :-)

> It always seems to be changing width from 1 -> 2 and back

Makes sense, that's 20 MHz <-> 40 MHz.

Did you buy a new device that says it's 40 MHz incompatible or
something? Or perhaps one of your neighbors did ... Or something is
causing interference that makes the AP switch around.

> $ dmesg | grep "changed bandwidth" | wc -l
> 42
> in 13 minutes of uptime. I have noticed this came in via 30eb1dc2c430
> ("mac80211: properly track HT/VHT operation changes").

Right, but that went into 3.9 :-)

> Is this something to be worried about?

Not at all. I suppose we could make this a debug message though, it's
not super useful when it happens OK (sometimes it causes disconnections
when we can't support the new mode, which is more relevant).

johannes

\
 
 \ /
  Last update: 2016-11-24 16:13    [W:0.123 / U:1.028 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site