Messages in this thread | | | Date | Mon, 21 Nov 2016 13:48:03 +0800 | From | miaoqing@codeauro ... | Subject | Re: [PATCH 4.9.0-rc5] AR9300 calibration problems with antenna selected |
| |
I would prefer that you didn't submit this.
> > I recently tried to select a single antenna on AR9300 and it works for > 30 seconds only. The subsequent calibration makes the RX signal level > to drop from the usual -30/-40 dBm to -70/-80 dBm, and the > transmission practically stops. > > With the attached patch it works, though selecting the antenna doesn't > seem to have any visible effect, at least with "iw wlanX station dump" > (perhaps it works for TX). > > I'm using ad-hoc mode: > > rmmod ath9k > modprobe ath9k > iw dev wlan0 set type ibss > iw phy phyX set antenna 2
2 is a bad mask. We use bitmap, the valid masks are 1, 3, 7.
-- Miaoqing
| |