lkml.org 
[lkml]   [2016]   [Nov]   [14]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
Date
From
Subject[PATCH v6] media: et8ek8: add device tree binding documentation
Add device tree binding documentation for toshiba et8ek8 sensor.

Signed-off-by: Ivaylo Dimitrov <ivo.g.dimitrov.75@gmail.com>
Signed-off-by: Pavel Machek <pavel@ucw.cz>

---

v6: added missing article, fixed signal polarity.

diff --git a/Documentation/devicetree/bindings/media/i2c/toshiba,et8ek8.txt b/Documentation/devicetree/bindings/media/i2c/toshiba,et8ek8.txt
new file mode 100644
index 0000000..b03b21d
--- /dev/null
+++ b/Documentation/devicetree/bindings/media/i2c/toshiba,et8ek8.txt
@@ -0,0 +1,53 @@
+Toshiba et8ek8 5MP sensor
+
+Toshiba et8ek8 5MP sensor is an image sensor found in Nokia N900 device
+
+More detailed documentation can be found in
+Documentation/devicetree/bindings/media/video-interfaces.txt .
+
+
+Mandatory properties
+--------------------
+
+- compatible: "toshiba,et8ek8"
+- reg: I2C address (0x3e, or an alternative address)
+- vana-supply: Analogue voltage supply (VANA), 2.8 volts
+- clocks: External clock to the sensor
+- clock-frequency: Frequency of the external clock to the sensor. Camera
+ driver will set this frequency on the external clock. The clock frequency is
+ a pre-determined frequency known to be suitable to the board.
+- reset-gpios: XSHUTDOWN GPIO. The XSHUTDOWN signal is active low. The sensor
+ is in hardware standby mode when the signal is in the low state.
+
+
+Endpoint node mandatory properties
+----------------------------------
+
+- remote-endpoint: A phandle to the bus receiver's endpoint node.
+
+Endpoint node optional properties
+----------------------------------
+
+- clock-lanes: <0>
+- data-lanes: <1..n>
+
+Example
+-------
+
+&i2c3 {
+ clock-frequency = <400000>;
+
+ cam1: camera@3e {
+ compatible = "toshiba,et8ek8";
+ reg = <0x3e>;
+ vana-supply = <&vaux4>;
+ clocks = <&isp 0>;
+ clock-frequency = <9600000>;
+ reset-gpio = <&gpio4 6 GPIO_ACTIVE_HIGH>; /* 102 */
+ port {
+ csi_cam1: endpoint {
+ remote-endpoint = <&csi_out1>;
+ };
+ };
+ };
+};
--
(english) http://www.livejournal.com/~pavelmachek
(cesky, pictures) http://atrey.karlin.mff.cuni.cz/~pavel/picture/horses/blog.html
[unhandled content-type:application/pgp-signature]
\
 
 \ /
  Last update: 2016-11-14 19:32    [W:0.120 / U:1.072 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site