lkml.org 
[lkml]   [2016]   [Nov]   [12]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v4 21/26] staging: iio: tsl2583: clarified comment about clearing interrupts
Date
The comment that describes the code that clears the interrupt bit was
vague and didn't provide much value. This patch adds more detail about
why that bit needs to be cleared.

Signed-off-by: Brian Masney <masneyb@onstation.org>
---
drivers/staging/iio/light/tsl2583.c | 5 +++--
1 file changed, 3 insertions(+), 2 deletions(-)

diff --git a/drivers/staging/iio/light/tsl2583.c b/drivers/staging/iio/light/tsl2583.c
index 806cb0a..727ed49 100644
--- a/drivers/staging/iio/light/tsl2583.c
+++ b/drivers/staging/iio/light/tsl2583.c
@@ -205,8 +205,9 @@ static int tsl2583_get_lux(struct iio_dev *indio_dev)
}

/*
- * clear status, really interrupt status (interrupts are off), but
- * we use the bit anyway - don't forget 0x80 - this is a command
+ * Clear the pending interrupt status bit on the chip to allow the next
+ * integration cycle to start. This has to be done even though this
+ * driver currently does not support interrupts.
*/
ret = i2c_smbus_write_byte(chip->client,
(TSL2583_CMD_REG | TSL2583_CMD_SPL_FN |
--
2.7.4
\
 
 \ /
  Last update: 2016-11-12 19:21    [W:0.432 / U:0.088 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site