lkml.org 
[lkml]   [2016]   [Nov]   [1]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v5 2/3] Documentation: Add binding document for Lattice iCE40 FPGA manager
Date
---
.../bindings/fpga/lattice-ice40-fpga-mgr.txt | 21 +++++++++++++++++++++
1 file changed, 21 insertions(+)
create mode 100644 Documentation/devicetree/bindings/fpga/lattice-ice40-fpga-mgr.txt

diff --git a/Documentation/devicetree/bindings/fpga/lattice-ice40-fpga-mgr.txt b/Documentation/devicetree/bindings/fpga/lattice-ice40-fpga-mgr.txt
new file mode 100644
index 0000000..cb64184
--- /dev/null
+++ b/Documentation/devicetree/bindings/fpga/lattice-ice40-fpga-mgr.txt
@@ -0,0 +1,21 @@
+Lattice iCE40 FPGA Manager
+
+Required properties:
+- compatible: Should contain "lattice,ice40-fpga-mgr"
+- reg: SPI chip select
+- spi-max-frequency: Maximum SPI frequency (>=1000000, <=25000000)
+- cdone-gpios: GPIO input connected to CDONE pin
+- reset-gpios: Active-low GPIO output connected to CRESET_B pin. Note
+ that unless the GPIO is held low during startup, the
+ FPGA will enter Master SPI mode and drive SCK with a
+ clock signal, potentially jamming other devices on the
+ bus until the firmware is loaded.
+
+Example:
+ ice40: ice40@0 {
+ compatible = "lattice,ice40-fpga-mgr";
+ reg = <0>;
+ spi-max-frequency = <1000000>;
+ cdone-gpios = <&gpio 24 GPIO_ACTIVE_HIGH>;
+ creset_b-gpios = <&gpio 22 GPIO_ACTIVE_LOW>;
+ };
--
2.7.4
\
 
 \ /
  Last update: 2016-11-01 05:48    [W:0.037 / U:0.472 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site