lkml.org 
[lkml]   [2016]   [Oct]   [26]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[RFC 3/3] regulator: fixed: dt: Allow an optional over current pin
Date
From: Axel Haslam <ahaslam@baylibre.com>

Add support for an optional over current input pin which
can be used to send an over current event to the regulator
consumer.

Cc: devicetree@vger.kernel.org
Signed-off-by: Axel Haslam <ahaslam@baylibre.com>
---
Documentation/devicetree/bindings/regulator/fixed-regulator.txt | 4 ++++
drivers/regulator/fixed.c | 8 ++++++++
2 files changed, 12 insertions(+)

diff --git a/Documentation/devicetree/bindings/regulator/fixed-regulator.txt b/Documentation/devicetree/bindings/regulator/fixed-regulator.txt
index 4fae41d..0c140cb 100644
--- a/Documentation/devicetree/bindings/regulator/fixed-regulator.txt
+++ b/Documentation/devicetree/bindings/regulator/fixed-regulator.txt
@@ -11,6 +11,8 @@ If this property is missing, the default assumed is Active low.
- gpio-open-drain: GPIO is open drain type.
If this property is missing then default assumption is false.
-vin-supply: Input supply name.
+- oc-gpio: Input gpio that signals an over current condition.
+- oc-active-high: The polarity of the over current pin is high.

Any property defined as part of the core regulator
binding, defined in regulator.txt, can also be used.
@@ -26,9 +28,11 @@ Example:
regulator-min-microvolt = <1800000>;
regulator-max-microvolt = <1800000>;
gpio = <&gpio1 16 0>;
+ oc-gpio = <&gpio1 18 0>;
startup-delay-us = <70000>;
enable-active-high;
regulator-boot-on;
gpio-open-drain;
+ oc-active-high;
vin-supply = <&parent_reg>;
};
diff --git a/drivers/regulator/fixed.c b/drivers/regulator/fixed.c
index 9937139..f02d24c 100644
--- a/drivers/regulator/fixed.c
+++ b/drivers/regulator/fixed.c
@@ -86,6 +86,14 @@ struct fixed_voltage_data {
if ((config->gpio < 0) && (config->gpio != -ENOENT))
return ERR_PTR(config->gpio);

+ config->oc_gpio = of_get_named_gpio(np, "oc-gpio", 0);
+ if (gpio_is_valid(config->oc_gpio))
+ config->has_oc_gpio = true;
+ else if (config->oc_gpio != -ENOENT)
+ return ERR_PTR(config->oc_gpio);
+
+ config->oc_high = of_property_read_bool(np, "oc-active-high");
+
of_property_read_u32(np, "startup-delay-us", &config->startup_delay);

config->enable_high = of_property_read_bool(np, "enable-active-high");
--
1.9.1
\
 
 \ /
  Last update: 2016-10-26 21:02    [W:0.091 / U:0.064 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site