lkml.org 
[lkml]   [2016]   [Oct]   [21]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [v7, 1/3] nand: pl353: Add basic driver for arm pl353 smc nand interface
On Mon, Jun 08, 2015 at 11:38:36PM +0530, Punnaiah Choudary Kalluri wrote:
> Add driver for arm pl353 static memory controller nand interface with
> HW ECC support. This controller is used in xilinx zynq soc for interfacing
> the nand flash memory.
>
> Signed-off-by: Punnaiah Choudary Kalluri <punnaia@xilinx.com>
> Changes in v7:
> - Currently not implemented the memclk rate adjustments. I will
> look into this later and once the basic driver is accepted.
> - Fixed GPL licence ident
> Changes in v6:
> - Fixed the checkpatch.pl reported warnings
> - Using the address cycles information from the onfi param page
> earlier it is hardcoded to 5 in driver
> Changes in v5:
> - Configure the nand timing parameters as per the onfi spec
> Changes in v4:
> - Updated the driver to sync with pl353_smc driver APIs
> Changes in v3:
> - implemented the proper error codes
> - further breakdown this patch to multiple sets
> - added the controller and driver details to Documentation section
> - updated the licenece to GPLv2
> - reorganized the pl353_nand_ecc_init function
> Changes in v2:
> - use "depends on" rather than "select" option in kconfig
> - remove unused variable parts
> - remove dummy helper and use writel_relaxed directly

What is the status of getting this driver merged? I am interested in
this driver and can provide some help if there are still TODO items.

At the very least I will test it, is there something newer than v7 out
there?

Regards,
Jason

\
 
 \ /
  Last update: 2016-10-21 22:35    [W:0.097 / U:0.140 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site