lkml.org 
[lkml]   [2016]   [Oct]   [19]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 10/10] bindings: gpio-sx150x: Document new bindings
Date
This patch documents the conversion of various platform data options
that used to be availible to SX150x driver to device tree/OF form.

Signed-off-by: Andrey Smirnov <andrew.smirnov@gmail.com>
---
.../devicetree/bindings/gpio/gpio-sx150x.txt | 29 ++++++++++++++++++++++
1 file changed, 29 insertions(+)

diff --git a/Documentation/devicetree/bindings/gpio/gpio-sx150x.txt b/Documentation/devicetree/bindings/gpio/gpio-sx150x.txt
index c809acb..e96b554 100644
--- a/Documentation/devicetree/bindings/gpio/gpio-sx150x.txt
+++ b/Documentation/devicetree/bindings/gpio/gpio-sx150x.txt
@@ -26,6 +26,35 @@ The GPIO expander can optionally be used as an interrupt controller, in
which case it uses the default two cell specifier as described in
Documentation/devicetree/bindings/interrupt-controller/interrupts.txt.

+Optional properties:
+
+- semtech,io-polarity: A bit-mask which enables polarity inversion for
+ each IO line in the expander. Setting the bit
+ at position n inverts the polarity of that IO
+ line, while clearing it results in normal
+ polarity. For chips with fewer than 16 IO pins,
+ high-end bits are ignored.
+
+- semtech,io-pullup:
+- semtech,io-pulldown: A bit-mask which enables-or disables the
+ pull-up (pull-down) resistor for each IO line
+ in the expander. Setting the bit at position n
+ will enable the pull-down for the IO at the
+ corresponding offset. For chips with fewer
+ than 16 IO pins, high-end bits are ignored.
+
+- semtech,reset-during-probe: Boolean, if true, the driver will
+ trigger a full reset of the chip at the
+ beginning of the probe in order to place
+ it in a known state.
+
+- semtech,oscio-is-gpo: Boolean, if set to true, the driver will
+ configure OSCIO as a GPO instead of as an
+ oscillator, increasing the size of the GP(I)O
+ pool created by this expander by one. The
+ output-only GPO pin will be added at the end
+ of the block.
+
Example:

i2c_gpio_expander@20{
--
2.5.5
\
 
 \ /
  Last update: 2016-10-19 16:20    [W:0.628 / U:0.100 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site