lkml.org 
[lkml]   [2016]   [Oct]   [18]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 1/2] dwc_eth_qos: do not clear pause flags from phy_device->supported
Date
From: Niklas Cassel <niklas.cassel@axis.com>

phy_device->supported is originally set by the PHY driver.
The ethernet driver should filter phy_device->supported to only contain
flags supported by the IP.
The IP supports setting rx and tx flow control independently,
therefore SUPPORTED_Pause and SUPPORTED_Asym_Pause should not be cleared.
If the flags are cleared, pause frames cannot be enabled (even if they
are supported by the PHY).

Signed-off-by: Niklas Cassel <niklas.cassel@axis.com>
Signed-off-by: Jesper Nilsson <jespern@axis.com>
Acked-by: Lars Persson <larper@axis.com>
---
drivers/net/ethernet/synopsys/dwc_eth_qos.c | 3 ++-
1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/drivers/net/ethernet/synopsys/dwc_eth_qos.c b/drivers/net/ethernet/synopsys/dwc_eth_qos.c
index 0d0053128542..d775729648ef 100644
--- a/drivers/net/ethernet/synopsys/dwc_eth_qos.c
+++ b/drivers/net/ethernet/synopsys/dwc_eth_qos.c
@@ -982,7 +982,8 @@ static int dwceqos_mii_probe(struct net_device *ndev)
if (netif_msg_probe(lp))
phy_attached_info(phydev);

- phydev->supported &= PHY_GBIT_FEATURES;
+ phydev->supported &= PHY_GBIT_FEATURES | SUPPORTED_Pause |
+ SUPPORTED_Asym_Pause;

lp->link = 0;
lp->speed = 0;
--
2.1.4
\
 
 \ /
  Last update: 2016-10-18 09:21    [W:0.195 / U:0.076 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site