Messages in this thread Patch in this message |  | | From | Niklas Cassel <> | Subject | [PATCH 2/2] dwc_eth_qos: enable flow control by default | Date | Mon, 17 Oct 2016 08:26:01 +0200 |
| |
From: Niklas Cassel <niklas.cassel@axis.com>
Allow autoneg to enable flow control by default. The behavior when autoneg is off has not changed.
Signed-off-by: Niklas Cassel <niklas.cassel@axis.com> Signed-off-by: Lars Persson <larper@axis.com> --- drivers/net/ethernet/synopsys/dwc_eth_qos.c | 1 + 1 file changed, 1 insertion(+)
diff --git a/drivers/net/ethernet/synopsys/dwc_eth_qos.c b/drivers/net/ethernet/synopsys/dwc_eth_qos.c index 93a3a919f723..8e39295427c0 100644 --- a/drivers/net/ethernet/synopsys/dwc_eth_qos.c +++ b/drivers/net/ethernet/synopsys/dwc_eth_qos.c @@ -992,6 +992,7 @@ static int dwceqos_mii_probe(struct net_device *ndev) lp->speed = 0; lp->duplex = DUPLEX_UNKNOWN; lp->phy_dev = phydev; + lp->flowcontrol.autoneg = AUTONEG_ENABLE; if (netif_msg_probe(lp)) { netdev_dbg(lp->ndev, "phy_addr 0x%x, phy_id 0x%08x\n", -- 2.1.4
|  |