Messages in this thread Patch in this message | | | From | Srinivas Kandagatla <> | Subject | [PATCH v2 2/9] arm64: dts: qcom: add correct drive strenght on cs pins | Date | Thu, 28 Jan 2016 17:43:30 +0000 |
| |
2mA drive strenght is not enough to drive chipselect low on hardware configurations with level shifters, 16mA should give good range to allow such configurations to work.
This issue was noticed while testing spi on db410c with sensor board.
Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org> --- arch/arm64/boot/dts/qcom/msm8916-pins.dtsi | 14 +++++++------- 1 file changed, 7 insertions(+), 7 deletions(-)
diff --git a/arch/arm64/boot/dts/qcom/msm8916-pins.dtsi b/arch/arm64/boot/dts/qcom/msm8916-pins.dtsi index 3bd917e..8d05005 100644 --- a/arch/arm64/boot/dts/qcom/msm8916-pins.dtsi +++ b/arch/arm64/boot/dts/qcom/msm8916-pins.dtsi @@ -81,8 +81,8 @@ bias-disable; }; pinconf_cs { - pins = "gpio2"; - drive-strength = <2>; + pins = "gpio16"; + drive-strength = <16>; bias-disable; output-high; }; @@ -116,7 +116,7 @@ }; pinconf_cs { pins = "gpio6"; - drive-strength = <2>; + drive-strength = <16>; bias-disable; output-high; }; @@ -150,7 +150,7 @@ }; pinconf_cs { pins = "gpio10"; - drive-strength = <2>; + drive-strength = <16>; bias-disable; output-high; }; @@ -184,7 +184,7 @@ }; pinconf_cs { pins = "gpio14"; - drive-strength = <2>; + drive-strength = <16>; bias-disable; output-high; }; @@ -218,7 +218,7 @@ }; pinconf_cs { pins = "gpio18"; - drive-strength = <2>; + drive-strength = <16>; bias-disable; output-high; }; @@ -252,7 +252,7 @@ }; pinconf_cs { pins = "gpio22"; - drive-strength = <2>; + drive-strength = <16>; bias-disable; output-high; }; -- 1.9.1
| |