lkml.org 
[lkml]   [2015]   [Sep]   [18]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 12/14] ARM: dts: qs600: add pwrseq support to WLAN
Date
Add pwrseq support to sdcc4 which would enable a proper reset of WLAN
without ugly hacks in the board support file.

Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
---
arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts | 32 +++++++++++++++++++++++++++++
1 file changed, 32 insertions(+)

diff --git a/arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts b/arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts
index 8aac3be..cc9d942 100644
--- a/arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts
+++ b/arch/arm/boot/dts/qcom-apq8064-cm-qs600.dts
@@ -1,4 +1,6 @@
#include "qcom-apq8064-v2.0.dtsi"
+#include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/pinctrl/qcom,pmic-gpio.h>

/ {
model = "CompuLab CM-QS600";
@@ -12,6 +14,20 @@
stdout-path = "serial0:115200n8";
};

+ pwrseq {
+ #address-cells = <1>;
+ #size-cells = <1>;
+ ranges;
+ compatible = "simple-bus";
+
+ sdcc4_pwrseq: sdcc4_pwrseq {
+ pinctrl-names = "default";
+ pinctrl-0 = <&wlan_default_gpios>;
+ compatible = "mmc-pwrseq-simple";
+ reset-gpios = <&pm8921_gpio 43 GPIO_ACTIVE_LOW>;
+ };
+ };
+
soc {
rpm@108000 {
regulators {
@@ -154,6 +170,21 @@
regulator-always-on;
};

+ qcom,ssbi@500000 {
+ pmic@0 {
+ gpio@150 {
+ wlan_default_gpios: wlan-gpios {
+ pios {
+ pins = "gpio43";
+ function = "normal";
+ bias-disable;
+ power-source = <PM8921_GPIO_S4>;
+ };
+ };
+ };
+ };
+ };
+
amba {
/* eMMC */
sdcc1: sdcc@12400000 {
@@ -172,6 +203,7 @@
status = "okay";
vmmc-supply = <&v3p3_fixed>;
vqmmc-supply = <&v3p3_fixed>;
+ mmc-pwrseq = <&sdcc4_pwrseq>;
};
};
};
--
1.9.1


\
 
 \ /
  Last update: 2015-09-18 14:41    [W:0.911 / U:0.104 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site