lkml.org 
[lkml]   [2015]   [Jul]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
    /
    From
    Subject[RESEND 00/10] regulator: pwm-regulator: Introduce continuous-mode
    Date
    This patch-set has been rebased on to v4.2-rc1.

    Continuous mode uses the PWM regulator's maximum and minimum supplied
    voltages specified in the regulator-{min,max}-microvolt properties to
    calculate appropriate duty-cycle values. This allows for a much more
    fine grained solution when compared with voltage-table mode, which
    this driver already supports. This solution does make an assumption
    that a %50 duty-cycle value will cause the regulator voltage to run
    at half way between the supplied max_uV and min_uV values.

    Lee Jones (10):
    ARM: multi_v7_defconfig: Enable ST's PWM driver
    ARM: multi_v7_defconfig: Enable ST's Power Reset driver
    ARM: multi_v7_defconfig: Enable support for PWM Regulators
    ARM: STi: STiH407: Move PWM nodes STiH407 => STiH407-family
    ARM: STi: STiH407: Add PWM Regulator node
    dt: regulator: pwm-regulator: Re-write bindings
    regulator: pwm-regulator: Separate voltage-table initialisation
    regulator: pwm-regulator: Add support for continuous-voltage
    regulator: pwm-regulator: Simplify voltage to duty-cycle call
    regulator: pwm-regulator: Don't assign structure attributes right away

    .../bindings/regulator/pwm-regulator.txt | 66 ++++++--
    arch/arm/boot/dts/stih407-family.dtsi | 41 +++++
    arch/arm/boot/dts/stih407.dtsi | 28 ----
    arch/arm/configs/multi_v7_defconfig | 3 +
    drivers/regulator/pwm-regulator.c | 172 ++++++++++++++++-----
    5 files changed, 234 insertions(+), 76 deletions(-)

    --
    1.9.1



    \
     
     \ /
      Last update: 2015-07-06 11:21    [W:3.167 / U:0.100 seconds]
    ©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site