Messages in this thread | | | Subject | Re: [PATCH v2] arm: koelsch: make USB0 perform Host/Function switching | From | Sergei Shtylyov <> | Date | Thu, 2 Jul 2015 14:32:11 +0300 |
| |
Hello.
On 7/2/2015 11:14 AM, Phil Edworthy wrote:
> Both USB Host (pci0) and Function (USBHS) drivers are enabled. > The USB PHY driver determines which IP block should be connected > based on vbus and id signals read via gpios.
> Note that switch SW5 and SW6 on Koelsch board needs to be set to > position 3 for this to work.
[...]
> diff --git a/arch/arm/boot/dts/r8a7791-koelsch.dts b/arch/arm/boot/dts/r8a7791-koelsch.dts > index cffe33f..1bb34d0 100644 > --- a/arch/arm/boot/dts/r8a7791-koelsch.dts > +++ b/arch/arm/boot/dts/r8a7791-koelsch.dts > @@ -615,7 +615,6 @@ > > &pci0 { > status = "okay"; > - pinctrl-0 = <&usb0_pins>; > pinctrl-names = "default";
As you're removing "pinctrl-0" prop, you also should remove "pinctrl-names".
> }; > > @@ -627,13 +626,15 @@ > > &hsusb { > status = "okay"; > - pinctrl-0 = <&usb0_pins>;
Likewise.
[...]
WBR, Sergei
| |