lkml.org 
[lkml]   [2015]   [Jul]   [13]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 2/2] ARM: dts: am57xx-beagle-x15: use palmas-usb for USB2
Date
The VBUS line of USB2 is connected to VBUS detect logic on
the PMIC. Use the palmas-usb driver to report VBUS events
to the USB driver.

As the palmas-usb driver supports GPIO based ID reporting
provide the GPIO for ID pin as well.

Signed-off-by: Roger Quadros <rogerq@ti.com>
---
arch/arm/boot/dts/am57xx-beagle-x15.dts | 25 ++++++++++++++++++-------
1 file changed, 18 insertions(+), 7 deletions(-)

diff --git a/arch/arm/boot/dts/am57xx-beagle-x15.dts b/arch/arm/boot/dts/am57xx-beagle-x15.dts
index a63bf78..bd185e0 100644
--- a/arch/arm/boot/dts/am57xx-beagle-x15.dts
+++ b/arch/arm/boot/dts/am57xx-beagle-x15.dts
@@ -98,13 +98,6 @@
pinctrl-0 = <&extcon_usb1_pins>;
};

- extcon_usb2: extcon_usb2 {
- compatible = "linux,extcon-usb-gpio";
- id-gpio = <&gpio7 24 GPIO_ACTIVE_HIGH>;
- pinctrl-names = "default";
- pinctrl-0 = <&extcon_usb2_pins>;
- };
-
hdmi0: connector {
compatible = "hdmi-connector";
label = "hdmi";
@@ -495,6 +488,16 @@
gpio-controller;
#gpio-cells = <2>;
};
+
+ extcon_usb2: tps659038_usb {
+ compatible = "ti,palmas-usb-vid";
+ ti,enable-vbus-detection;
+ ti,enable-gpio-id-detection;
+ id-gpios = <&gpio7 24 GPIO_ACTIVE_HIGH>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&extcon_usb2_pins>;
+ };
+
};

tmp102: tmp102@48 {
@@ -624,6 +627,14 @@
};

&usb2 {
+ /*
+ * Stand alone usage is peripheral only.
+ * However, with some resistor modifications
+ * this port can be used via expansion connectors
+ * as "host" or "dual-role". If so, provide
+ * the necessary dr_mode override in the expansion
+ * board's DT.
+ */
dr_mode = "peripheral";
};

--
2.1.4


\
 
 \ /
  Last update: 2015-07-13 15:21    [W:0.035 / U:1.916 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site