lkml.org 
[lkml]   [2015]   [Jun]   [3]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 11/11] dt: Exynos: add Snow SPI NOR node.
On 04.06.2015 06:26, Michal Suchanek wrote:
> The Snow has onboard SPI NOR flash which contains the bootloader.
>
> Add DT node for this flash chip. The flash is rated 133MHz but the pl330
> controller can transfer only up to 128 bytes at this speed so use more
> conservative settings. Even at 40MHz pl330 can transfer at most 64k with
> the current driver.
>
> Signed-off-by: Michal Suchanek <hramrach@gmail.com>
> ---
> arch/arm/boot/dts/exynos5250-snow.dts | 12 ++++++++++++
> 1 file changed, 12 insertions(+)
>
> diff --git a/arch/arm/boot/dts/exynos5250-snow.dts b/arch/arm/boot/dts/exynos5250-snow.dts
> index 1fa72cf..38e4cda 100644
> --- a/arch/arm/boot/dts/exynos5250-snow.dts
> +++ b/arch/arm/boot/dts/exynos5250-snow.dts
> @@ -691,6 +691,18 @@
> num-cs = <1>;
> cs-gpios = <&gpa2 5 0>;
> status = "okay";
> + flash: m25p80@0 {

The indentation looks odd. This should be at the same level as "status".

> + #address-cells = <1>;
> + #size-cells = <1>;
> + compatible = "jedec,spi-nor";
> + reg = <0>;
> + spi-max-frequency = <40000000>;

So actually you wanted 133 MHz but as a workaround for DMA issue you use
40 MHz, right? Could you add here a small TODO note in comment about it?

Best regards,
Krzysztof


\
 
 \ /
  Last update: 2015-06-04 04:21    [W:0.108 / U:0.144 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site