lkml.org 
[lkml]   [2015]   [Jun]   [23]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
    Patch in this message
    /
    From
    Subject[PATCH 01/17] phy: ti-pipe3: use ti_pipe3_power_off to power off the PHY during probe
    Date
    No functional change. Previously omap_control_phy_power() was used to power
    off the PHY during probe. But once PIPE3 driver is adapted to use syscon,
    omap_control_phy_power() cannot be used. Hence used ti_pipe3_power_off
    to power off the PHY.

    Signed-off-by: Kishon Vijay Abraham I <kishon@ti.com>
    ---
    drivers/phy/phy-ti-pipe3.c | 4 ++--
    1 file changed, 2 insertions(+), 2 deletions(-)

    diff --git a/drivers/phy/phy-ti-pipe3.c b/drivers/phy/phy-ti-pipe3.c
    index 08020dc..d784426 100644
    --- a/drivers/phy/phy-ti-pipe3.c
    +++ b/drivers/phy/phy-ti-pipe3.c
    @@ -431,8 +431,6 @@ static int ti_pipe3_probe(struct platform_device *pdev)

    phy->control_dev = &control_pdev->dev;

    - omap_control_phy_power(phy->control_dev, 0);
    -
    platform_set_drvdata(pdev, phy);
    pm_runtime_enable(phy->dev);

    @@ -451,6 +449,8 @@ static int ti_pipe3_probe(struct platform_device *pdev)
    return PTR_ERR(generic_phy);

    phy_set_drvdata(generic_phy, phy);
    + ti_pipe3_power_off(generic_phy);
    +
    phy_provider = devm_of_phy_provider_register(phy->dev,
    of_phy_simple_xlate);
    if (IS_ERR(phy_provider))
    --
    1.7.9.5


    \
     
     \ /
      Last update: 2015-06-23 14:21    [W:4.259 / U:0.064 seconds]
    ©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site