Messages in this thread | | | Date | Thu, 18 Jun 2015 11:39:16 +0300 | Subject | Re: [PATCH v2] Input: Add generic driver for Zeitec touchscreens | From | Bogdan George Stefan <> |
| |
Dimitry,
You can control how many fingers work on a device via the firmware that you load. I've asked the Zeitec guys to confirm. So, to answer your question, if you want to build a system with a touch that supports only 7 fingers, you can pick any part from Zeitec and give the supplier the right firmware.
Thank you, Bogdan Stefan
On Fri, Jun 12, 2015 at 3:45 AM, Dmitry Torokhov <dmitry.torokhov@gmail.com> wrote: > > Hi Bogdan, > > On Tue, Jun 02, 2015 at 10:43:01AM +0300, Bogdan George Stefan wrote: > > Dimitry, > > > > I know 0xB2 should provide that information according to the > > datasheet, however here is what Zeitec guys had to say when I asked > > them why it does not work: > > > > "0xB2 is deprecated. > > It only supports in Zet6221/31 serious but zet9172/zet6273." > > > > If you like, I can attach my conversation with them. > > > > Not really, but I would like to understand how the part selection works. > Are they the same parts or different parts? Let's say you want to build > a system and you want part that reports up to 7 contacts. How do you > communicate this to the supplier? The number of contacts - is it > controller by the config file you load into the controller, or they have > separate parts for different contact count or what? > > Thanks. > > -- > Dmitry
| |