[lkml]   [2015]   [May]   [8]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH 02/12] clocksource: sti: Provide support for the ST LPC Clocksource IP
On Fri, 08 May 2015, Paul Bolle wrote:

> On Thu, 2015-05-07 at 14:38 +0100, Lee Jones wrote:
> > --- a/drivers/clocksource/Kconfig
> > +++ b/drivers/clocksource/Kconfig
> > +config CLKSRC_ST_LPC
> > + bool
> > + depends on ARCH_STI
> By itself this does nothing. You can't set this symbol to 'y', even if
> ARCH_STI is 'y', right? Of course, ARCH_STI will select this symbol (see
> 11/12) otherwise it would be inert. But as ARCH_STI selects
> CLKSRC_ST_LPC I'd say this dependency isn't actually needed.

I guess this is more of a representative dependency, but you're right,
the likelihood is that no one is likely to accidentally enable it.

I can remove it.

> Are other selects of CLKSRC_ST_LPC expected to be added in the future?
> If not, CLKSRC_ST_LPC should operate in lockstep with ARCH_STI. In that
> case you might as well not bother with CLKSRC_ST_LPC and use ARCH_STI
> directly. (But that forces you to move the select statement below into
> the ARCH_STI entry, which might be ugly.)

Although true, there might be cases where we need to stop this from
being enabled on all ARCH_STI platforms. It'll be easier to move
CLKSRC_ST_LPC around in arch code than to start renaming this symbol.

I'd prefer to keep this as CLKSRC_ST_LPC if you're not passionate
about the alternative.

> > + select CLKSRC_OF if OF
> > + help
> > + Enable this option to use the Low Power controller timer
> > + as clocksource.
> (Please add an empty line.)

I believe the new line comes in the next patch.

Lee Jones
Linaro STMicroelectronics Landing Team Lead │ Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog

 \ /
  Last update: 2015-05-08 12:41    [W:0.133 / U:6.736 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site