lkml.org 
[lkml]   [2015]   [May]   [21]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH] spmi: add command tracepoints for SPMI
From
> On 05/18/15 14:51, Ankit Gupta wrote:
>> Add tracepoints to retrieve information about read, write
>> and non-data commands. For performance measurement support
>> tracepoints are added at the beginning and at the end of
>> transfers. Following is a list showing the new tracepoint
>> events. The "cmd" parameter here represents the opcode, SID,
>> and full 16-bit address.
>>
>> spmi_write_begin: cmd and data buffer.
>> spmi_write_end : cmd and return value.
>> spmi_read_begin : cmd.
>> spmi_read_end : cmd, return value and data buffer.
>> spmi_cmd : cmd.
>>
>> The reason that cmd appears at both the beginning and at
>> the end event is that SPMI drivers can request commands
>> concurrently. cmd helps in matching the corresponding
>> events.
>>
>> SPMI tracepoints can be enabled like:
>>
>> echo 1 >/sys/kernel/debug/tracing/events/spmi/enable
>>
>> and will dump messages that can be viewed in
>> /sys/kernel/debug/tracing/trace that look like:
>>
>> ... spmi_read_begin: opc=56 sid=00 addr=0x0000
>> ... spmi_read_end: opc=56 sid=00 addr=0x0000 ret=0 len=02 buf=0x[01-40]
>> ... spmi_write_begin: opc=48 sid=00 addr=0x0000 len=3 buf=0x[ff-ff-ff]
>>
>> Signed-off-by: Ankit Gupta <ankgupta@codeaurora.org>
>> Signed-off-by: Gilad Avidov <gavidov@codeaurora.org>
>> Suggested-by: Sagar Dharia <sdharia@codeaurora.org>
>> ---
>
> Assuming you fix sign-off-chain:
>
> Reviewed-by: Stephen Boyd <sboyd@codeaurora.org>

Sorry, Missed your this email, will upload a new patch with just change of
sign-off order.

Thanks
>
> --
> Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum,
> a Linux Foundation Collaborative Project
>
>




\
 
 \ /
  Last update: 2015-05-22 02:01    [W:0.184 / U:0.068 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site