Messages in this thread | | | Date | Wed, 13 May 2015 12:09:15 +0100 | From | Mark Brown <> | Subject | Re: [PATCH] RFC: mmc: core: Increase delay for voltage to stabilize from 3.3V to 1.8V |
| |
On Tue, May 12, 2015 at 02:46:11PM -0700, Doug Anderson wrote: > Since the regulator used for the SDMMC IO voltage is not expected to > draw a lot of current, most systems will probably use an inexpensive > LDO for it. LDO regulators apparently have the feature that they > don't actively drive the voltage down--they wait for other components > in the system to drag the voltage down. Thus they will transition > faster under heavy loads and slower under light loads.
What a LDO is doing is basically just charging up a capacitor - the regulation consists of monitoring the voltage on the capacitor and opening a transistor to charge the capacitor when the voltage droops too much.
> From experimental evidence, we've seen the voltage change fail if the > card doesn't detect that the voltage fell to less than about 2.3V when > we turn on the clock. On one device (that admittedly had a 47K CMD > pullup instead of a 10K CMD pullup) we saw that the voltage was just > about 2.3V after 5ms and thus the voltage change would sometimes fail. > Doubling the delay gave margin and made the voltage change work 100% > of the time, despite the slightly weaker CMD pull.
> At the moment submitting this as an RFC patch since my problem _could_ > be fixed by increasing the pull strength (or using a smaller > capacitor). However being a little bit more lenient to strange > hardware could also be a good thing.
Right, and this is probably going beyond the delays that the regulator API is handling since it's not something the regulator hardware is actively managing. [unhandled content-type:application/pgp-signature] | |