lkml.org 
[lkml]   [2015]   [May]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[RESEND PATCH v3 09/10] mfd: arizona: Add better support for system suspend
Date
Allow the chip to completely power off if we enter runtime suspend and
there is no jack detection active. This is helpful for systems where
system suspend might remove the supplies to the CODEC, without informing
us. Note the powering off is done in runtime suspend rather than system
suspend, because we need to hold reset until the first time DCVDD is
powered anyway (which would be in runtime resume), and we might as well
save the extra power.

Signed-off-by: Charles Keepax <ckeepax@opensource.wolfsonmicro.com>
Acked-by: Lee Jones <lee.jones@linaro.org>
---
drivers/mfd/arizona-core.c | 94 +++++++++++++++++++++++++++++++-------
include/linux/mfd/arizona/core.h | 1 +
2 files changed, 78 insertions(+), 17 deletions(-)

diff --git a/drivers/mfd/arizona-core.c b/drivers/mfd/arizona-core.c
index 93024ac..f1ff68a 100644
--- a/drivers/mfd/arizona-core.c
+++ b/drivers/mfd/arizona-core.c
@@ -442,12 +442,33 @@ static int arizona_runtime_resume(struct device *dev)

dev_dbg(arizona->dev, "Leaving AoD mode\n");

+ if (arizona->has_fully_powered_off) {
+ dev_dbg(arizona->dev, "Re-enabling core supplies\n");
+
+ ret = regulator_bulk_enable(arizona->num_core_supplies,
+ arizona->core_supplies);
+ if (ret) {
+ dev_err(dev, "Failed to enable core supplies: %d\n",
+ ret);
+ return ret;
+ }
+ }
+
ret = regulator_enable(arizona->dcvdd);
if (ret != 0) {
dev_err(arizona->dev, "Failed to enable DCVDD: %d\n", ret);
+ if (arizona->has_fully_powered_off)
+ regulator_bulk_disable(arizona->num_core_supplies,
+ arizona->core_supplies);
return ret;
}

+ if (arizona->has_fully_powered_off) {
+ arizona_disable_reset(arizona);
+ enable_irq(arizona->irq);
+ arizona->has_fully_powered_off = false;
+ }
+
regcache_cache_only(arizona->regmap, false);

switch (arizona->type) {
@@ -508,6 +529,14 @@ static int arizona_runtime_resume(struct device *dev)
goto err;
}
}
+
+ ret = wm5110_apply_sleep_patch(arizona);
+ if (ret) {
+ dev_err(arizona->dev,
+ "Failed to re-apply sleep patch: %d\n",
+ ret);
+ goto err;
+ }
break;
default:
ret = arizona_wait_for_boot(arizona);
@@ -545,10 +574,17 @@ err:
static int arizona_runtime_suspend(struct device *dev)
{
struct arizona *arizona = dev_get_drvdata(dev);
+ unsigned int val;
int ret;

dev_dbg(arizona->dev, "Entering AoD mode\n");

+ ret = regmap_read(arizona->regmap, ARIZONA_JACK_DETECT_ANALOGUE, &val);
+ if (ret) {
+ dev_err(dev, "Failed to check jack det status: %d\n", ret);
+ return ret;
+ }
+
if (arizona->external_dcvdd) {
ret = regmap_update_bits(arizona->regmap,
ARIZONA_ISOLATION_CONTROL,
@@ -559,33 +595,57 @@ static int arizona_runtime_suspend(struct device *dev)
ret);
return ret;
}
- } else {
- switch (arizona->type) {
- case WM5110:
- case WM8280:
- /*
- * As this is only called for the internal regulator
- * (where we know voltage ranges available) it is ok
- * to request an exact range.
- */
- ret = regulator_set_voltage(arizona->dcvdd,
- 1175000, 1175000);
- if (ret < 0) {
+ }
+
+ switch (arizona->type) {
+ case WM5110:
+ case WM8280:
+ if (arizona->external_dcvdd)
+ break;
+
+ /*
+ * As this is only called for the internal regulator
+ * (where we know voltage ranges available) it is ok
+ * to request an exact range.
+ */
+ ret = regulator_set_voltage(arizona->dcvdd, 1175000, 1175000);
+ if (ret < 0) {
+ dev_err(arizona->dev,
+ "Failed to set suspend voltage: %d\n", ret);
+ return ret;
+ }
+ break;
+ case WM5102:
+ if (!(val & ARIZONA_JD1_ENA))
+ ret = regmap_write(arizona->regmap,
+ ARIZONA_WRITE_SEQUENCER_CTRL_3, 0x0);
+ if (ret) {
dev_err(arizona->dev,
- "Failed to set suspend voltage: %d\n",
+ "Failed to clear write sequencer: %d\n",
ret);
return ret;
}
- break;
- default:
- break;
- }
+ break;
+ default:
+ break;
}

regcache_cache_only(arizona->regmap, true);
regcache_mark_dirty(arizona->regmap);
regulator_disable(arizona->dcvdd);

+ /* Allow us to completely power down if no jack detection */
+ if (!(val & ARIZONA_JD1_ENA)) {
+ dev_dbg(arizona->dev, "Fully powering off\n");
+
+ arizona->has_fully_powered_off = true;
+
+ disable_irq(arizona->irq);
+ arizona_enable_reset(arizona);
+ regulator_bulk_disable(arizona->num_core_supplies,
+ arizona->core_supplies);
+ }
+
return 0;
}
#endif
diff --git a/include/linux/mfd/arizona/core.h b/include/linux/mfd/arizona/core.h
index 16a498f..847bdaf 100644
--- a/include/linux/mfd/arizona/core.h
+++ b/include/linux/mfd/arizona/core.h
@@ -117,6 +117,7 @@ struct arizona {
int num_core_supplies;
struct regulator_bulk_data core_supplies[ARIZONA_MAX_CORE_SUPPLIES];
struct regulator *dcvdd;
+ bool has_fully_powered_off;

struct arizona_pdata pdata;

--
1.7.2.5


\
 
 \ /
  Last update: 2015-05-11 15:41    [W:0.290 / U:0.036 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site