[lkml]   [2015]   [Apr]   [17]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
Patch in this message
Subject[PATCH 3.14 31/43] tty: serial: fsl_lpuart: clear receive flag on FIFO flush
3.14-stable review patch.  If anyone has any objections, please let me know.


From: Stefan Agner <>

commit 8e4934c6d6c659e22b1b746af4196683e77ce6ca upstream.

When the receiver was enabled during startup, a character could
have been in the FIFO when the UART get initially used. The
driver configures the (receive) watermark level, and flushes the
FIFO. However, the receive flag (RDRF) could still be set at that
stage (as mentioned in the register description of UARTx_RWFIFO).
This leads to an interrupt which won't be handled properly in
interrupt mode: The receive interrupt function lpuart_rxint checks
the FIFO count, which is 0 at that point (due to the flush
during initialization). The problem does not manifest when using
DMA to receive characters.

Fix this situation by explicitly read the status register, which
leads to clearing of the RDRF flag. Due to the flush just after
the status flag read, a explicit data read is not to required.

Signed-off-by: Stefan Agner <>
Signed-off-by: Greg Kroah-Hartman <>

drivers/tty/serial/fsl_lpuart.c | 3 +++
1 file changed, 3 insertions(+)

--- a/drivers/tty/serial/fsl_lpuart.c
+++ b/drivers/tty/serial/fsl_lpuart.c
@@ -362,6 +362,9 @@ static void lpuart_setup_watermark(struc
sport->port.membase + UARTPFIFO);

+ /* explicitly clear RDRF */
+ readb(sport->port.membase + UARTSR1);
/* flush Tx and Rx FIFO */
sport->port.membase + UARTCFIFO);

 \ /
  Last update: 2015-04-17 16:21    [W:0.165 / U:8.964 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site