[lkml]   [2015]   [Apr]   [16]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH 1/3] sched, timer: Remove usages of ACCESS_ONCE in the scheduler
On Thu, Apr 16, 2015 at 08:02:27PM +0200, Ingo Molnar wrote:
> > ACCESS_ONCE() is not a compiler barrier
> It's not a general compiler barrier (and I didn't claim so) but it is
> still a compiler barrier: it's documented as a weak, variable specific
> barrier in Documentation/memor-barriers.txt:

Ok, fair enough. I just don't generally think of them as 'barriers'.

> > The 'read' side uses ACCESS_ONCE() for two purposes:
> > - to load the value once, we don't want the seq number to change under
> > us for obvious reasons
> > - to avoid load tearing and observe weird seq numbers
> >
> > The update side uses ACCESS_ONCE() to avoid write tearing, and
> > strictly speaking it should also worry about read-tearing since its
> > not hard serialized, although its very unlikely to actually have
> > concurrency (IIRC).

> This is what I meant by that there's no harm from this race.

Ok, but I would still like to preserve the READ one on the usage site
and the WRITE one on the update side, if only as documentation that
there's something 'special' happening.

And while the effects here might end up being statistical noise, I have
conceptual problems with re-reading seq counts, that's not proper.

And its not like they really cost anything.

 \ /
  Last update: 2015-04-16 20:21    [W:0.092 / U:10.680 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site